After configuring and applying a tunnel selector, run the
following commands to check information about the tunnel selector
and tunnel policy in the system.
Procedure
- Run the display tunnel-selector tunnel-selector-name command to check
detailed information about a tunnel selector.
- Run the display tunnel-policy tunnel-policy-name command to check information
about the apply clause of a tunnel selector.
- Run the display bgp vpnv4 all routing-table ipv4-address [ mask [ longer-prefixes ] | mask-length [ longer-prefixes ] ] command to check information about
the tunnels to which VPNv4 routes on the ASBR recurse.
- Run the display bgp vpnv6 all routing-table ipv6-address [ prefix-length ] command to check information
about the tunnels to which VPNv6 routes on the ASBR recurse.
- Run
the display ip routing-table ip-address [ mask | mask-length ] [ longer-match ] verbose command
to check information about the tunnels to which labeled BGP-IPv4 routes
on the PE recurse.
- Run the display ipv6 routing-table ipv6-address [ prefix-length ] [ longer-match ] verbose command to check information
about the tunnels to which the labeled BGP-IPv6 routes on the PE recurse.
- Run the display tunnel-info { tunnel-id tunnel-id | all | statistics } command to check information about tunnels in the system.