(Optional) Configuring VSI PW-based Traffic Suppression

Procedure

1. Run system-view

   The system view is displayed.

2. Run vsi vsi-name [ static | auto ]

   The VSI view is displayed.

3. Run pwsignal ldp

   The VSI-LDP view is displayed.

4. Run vsi-id vsi-id

   The VSI ID is configured.

5. Run peer peer-address [ negotiation-vc-id vc-id ] pw pw-name

   A PW was created, and the VSI-LDP-PW view is displayed.

6. (Optional) Run pw pw-name

   The VSI-LDP-PW view is displayed.

   After you create the PW in Step 5, you can run this command to enter the VSI-LDP-PW view in the VSI-LDP view.

7. Run the following commands as required:
   • Run broadcast-suppression cir cir-value [ cbs cbs-value ]

     The rate of the broadcast packets on the VSI PW is limited.

   • Run multicast-suppression cir cir-value [ cbs cbs-value ]

     The rate of the multicast packets on the VSI PW is limited.

   When the packet rate reaches the CIR, subsequent packets are discarded.

8. Run commit

   The configuration is committed.