After configuring LDP VPLS, check information about VSIs, remote VSIs, VPLS connections, outbound interfaces of VSI PWs, and tunnel policies applied to VSIs.
Prerequisites
LDP VPLS has been configured.
Procedure
- Run the display vsi [ name vsi-name ] [ verbose ] command to check information about VPLS VSIs.
- Run the display vsi remote ldp [ [ router-id ip-address ] [ pw-id pw-id ] | unmatch | verbose ] command to check information about the remote VSI.
- Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command to check information about the VPLS connection.
- Run the display vsi pw out-interface [ vsi vsi-name ] command to check information about the outbound interface of the VSI PW.
- Run the display l2vpn vsi-list tunnel-policy policy-name command to check information about the tunnel policy used by the VSI.
- Run the display vpls forwarding-info [ state { up | down } | vsi vsi-name [ peer peer-address [ negotiation-vc-id vc-id ] ] ] [ verbose ] command to check the forwarding information of all VSIs.
- Run the display vsi services { vsi-name | all | interface interface-type interface-number | vlan vlan-id } command to check information about the AC interface associated with the VSI.
- Run the display admin-vsi binding [ admin-vsi vsi-name ] command to check information about the binding of the mVSI and the service VSI.
- Run the display mpls label-stack vpls vsi vsi-name peer peer-id vc-id vc-id command to check label stack information.
- Run the display vsi { name vsi-name peer-info [ peer-ip-address ] | peer-info } command to check peer PW status information.