Configuring Traffic Statistics Collection for VPLS QoS

You can collect VPLS QoS traffic statistics in real time to check whether the QoS requirements are met.

Usage Scenario

To monitor network operating status and locate problems in an easier way on a VPLS network, you can configure traffic statistics collection for VPLS QoS.

If VPLS QoS and VPLS traffic statistics collection are both configured, you can determine whether the QoS requirements of VPLS services are met based on VPLS QoS traffic statistics collected in real time.

Pre-configuration Tasks

Before configuring QoS-based traffic statistics collection for a VPLS VSI, complete the following tasks:

Configure a VPLS VSI.
Configure VPLS QoS.

Before configuring QoS-based traffic statistics collection for a VPLS-VSI PW, complete the following tasks:

Configure a VPLS VSI.
Configure a PW for the VPLS VSI.
Configure VPLS QoS.

Statistics about QoS-based VPLS traffic can be collected for a VSI or for a VSI PW. QoS-based traffic statistics collection for a VSI takes effect to all PWs in the VSI. QoS-based traffic statistics collection for a VSI PW takes effect to a specified PW in an LDP VSI.

Procedure

Configure QoS-based traffic statistics collection for a VPLS VSI.
1. Run system-view
  The system view is displayed.
2. Run vsi vsi-name
  A VSI is created, and the VSI view is displayed.
3. Run qos cir cir-value [ pir pir-value ] [ qos-profile qos-profile-name ]
  QoS parameters are configured for the VSI.
4. Run traffic-statistics enable
  Traffic statistics collection for VPLS QoS is enabled.
5. Run commit
  The configuration is committed.
Configure QoS-based traffic statistics collection for a VPLS-VSI PW.
1. Run system-view
  The system view is displayed.
2. Run vsi vsi-name
  A VSI is created, and the VSI view is displayed.
3. Run pwsignal ldp
  The LDP signaling mode is configured for the VSI, and the VSI-LDP view is displayed.
4. Run pw pw-name
  A PW is created, and the VSI-LDP-PW view is displayed.
5. Run qos cir cir-value [ pir pir-value ] [ qos-profile qos-profile-name ]
  QoS parameters are configured for the LDP PW.
6. Run traffic-statistics enable
  Traffic statistics collection for VPLS QoS is enabled.
7. Run commit
  The configuration is committed.

Verifying the Configuration

After configuring traffic statistics collection for VPLS QoS, verify the configuration.

Run the display traffic-statistics vsi vsi-name qos [ peer peer-address [ ldp129 | negotiation-vc-id vc-id | remote-site remote-site-id ] ] command to check VPLS QoS traffic statistics.