After configuring VXLAN in distributed gateway mode using BGP EVPN, verify the configuration, and you can find that VXLAN tunnels are dynamically established and are in the Up state.
Prerequisites
VXLAN in distributed gateway mode has been configured using BGP EVPN.
Procedure
- Run the display bridge-domain [ binding-info | [ bd-id [ brief | verbose | binding-info ] ] ] command to check BD configurations.
- Run the display interface nve [ nve-number | main ] command to check NVE interface information.
- Run the display bgp evpn peer [ [ ipv4-address ] verbose ] command to check BGP EVPN peer information.
- Run the display vxlan peer [ vni vni-id ] command to check ingress replication lists of a VNI or all VNIs.
- Run the display vxlan tunnel [ tunnel-id ] [ verbose ] command to check VXLAN tunnel information.
- Run the display vxlan vni [ vni-id [ verbose ] ] command to check VNI information.
- Run the display interface vbdif [ bd-id ] command to check VBDIF interface information and statistics.
- Run the display mac-limit bridge-domain bd-id command to check MAC address limiting configurations of a BD.
- Run the display bgp evpn all routing-table command to check EVPN route information.