CLKMIB_1.3.6.1.4.1.2011.5.25.186.1.8.5 hwClockSourceFreqCheck

Description

CLKMIB/4/CLOCKSOURCEFREQCHECK: OID [oid] The check of frequence abnormal notification. (hwClockSrcCfgChassisIndex = [integer], hwClockSrcCfgSourceTypeIndex = [integer], hwClockSrcCfgSourceIndex = [integer], hwClockChassisId = [integer], hwClockCurSourceName = [STRING], hwClockSrcCfgFreqCheckResult = [integer])

The frequency offset detection functioned abnormally.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.186.1.8.5	Warning	equipmentAlarm(5)

Parameters

Name	Meaning
[oid]	Indicates the MIB object ID of the alarm.
hwClockSrcCfgChassisIndex	Indicates the index of the device where the clock source resides. The index is always 1 for a single device.
hwClockSrcCfgSourceTypeIndex	Indicates the index of the clock source type. The value can be: System(1): system phase-locked loop sync2M-1(2): 2M phase-locked loop-1 sync2M-2(3): 2M phase-locked loop-2
hwClockSrcCfgSourceIndex	Indicates the clock source index.
hwClockChassisId	Indicates the ID of the device where the clock source resides.
hwClockCurSourceName	Indicates the current clock source name.
hwClockSrcCfgFreqCheckResult	Indicates the result of frequency check.

Impact on the System

This clock source will not be traced by the system clock.

Possible Causes

When the absolute frequency offset of the traced clock source is larger than 9.2 ppm, an alarm is reported, indicating that frequency offset detection functions abnormally.

Procedure

Run the display clock source command to check the current status of the clock source.
- If the clock source is in the abnormal state, it indicates that the frequency offset detection is abnormal. In this case, go to Step 3.
- If the clock source is in another state, go to Step 2.
Collect alarm information and configuration information, and then contact technical support personnel.
End.