IFPDT_1.3.6.1.4.1.2011.5.25.157.2.157.19 hwPortErrorRateExceed

Description

IFPDT/1/ERRORRATEEXCEED: OID [OID] The interface rate of incoming error packets exceeded the trap threshold, which may affect forwarding. Handle it as soon as possible. (InterfaceIndex=[INTEGER], InterfaceName=[OCTET], ErrorRate=[OCTET], TrapThreshold=[OCTET])

The rate at which an interface received CRC, Giants, and Runts error packets equaled or exceeded 1000 packets per second.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.157.2.157.19	Critical	qualityOfServiceAlarm(3)

Parameters

Name	Meaning
OID	Indicates the MIB object ID of the alarm.
InterfaceIndex	Indicates the interface index.
InterfaceName	Indicates the interface name.
ErrorRate	Indicates the error packet rate.
TrapThreshold	Indicates the trap threshold.

Impact on the System

This interface may discard some service data.

Possible Causes

Cause 1: The optical module failed.

Cause 2: The optical fiber failed.

Cause 3: The length of frames received by the interface was too long.

Procedure

Replace the optical module and run the display interface command to check whether the number of error packets received by the interface keeps increasing.
1. If so, go to step 2.
2. If not, go to step 5.
Replace the optical fiber and run the display interface command to check whether the number of error packets received by the interface keeps increasing.
1. If so, go to step 3.
2. If not, go to step 5.
Run the jumboframe enable command to modify the restriction on packet length or modify the packet length, and then run the display interface command to check whether the number of error packets received by the interface keeps increasing.
1. If so, go to step 4.
2. If not, go to step 5.
Collect trap, log, and configuration information, and contact technical support personnel.
End.