OSPFV3_1.3.6.1.4.1.2011.5.25.147.0.16 hwOspfv3PeerFlappingSuppressStatusChange

Description

OSPFV3/2/NBRDAMP_SUPPRESS: OID [oid] The status of peer flapping suppress is changed.(ProcessId=[integer], RouterId=[integer], AreaId=[integer], ifName=[octet], SuppressStatus=[integer], SuppressReason=[integer])

The status of OSPFv3 neighbor relationship flapping suppression changed.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.147.0.16	Major	communicationsAlarm

Parameters

Name	Meaning
oid	Indicates the MIB object ID of the alarm.
ProcessId	Process ID
RouterId	Router ID
AreaId	Area ID
ifName	Interface name
SuppressStatus	Suppression status
SuppressReason	Suppression causes are as follows: 1: The interval between two successive neighbor status changes from Full to a non-Full state was longer than the resume interval. 2: A configuration was changed. For example, the OSPFv3 process was reset. 3: An interface was forced to exit from OSPFv3 neighbor relationship flapping suppression using the reset ospfv3 suppress-flapping peer command. 4: The OSPFv3 neighbor relationship flapped frequently. 5: OSPFv3 neighbor relationship flapping suppression exited from Hold-down mode and began to work in Hold-max-cost mode.

Impact on the System

Services may be interrupted if OSPFv3 neighbor relationship flapping suppression persists on the interface.

Possible Causes

OSPFv3 neighbor relationship flapping suppression started, or the interface exited from the suppression.

Procedure

Run the display interface command multiple times to check whether interface flapping frequently occurs.
- If frequent interface flapping occurs, this trap message is informational only and no action is required.
- If no frequent interface flapping occurs, go to Step 2.
Run the reset ospfv3 process-id suppress-flapping peer [ interface-type interface-number ] [ notify-peer ] command to force the interface to exit from OSPFv3 neighbor relationship flapping suppression.
End.

Related Information

None