RRPP_1.3.6.1.4.1.2011.5.25.113.4.3 hwRrppMultiMaster

Description

RRPP/2/MULMAST:OID [oid] A conflicting master node was detected on RRPP domain [domain-id] ring [ring-id].

The RRPP ring had more than one master node.

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.113.4.3	Major	processingErrorAlarm(4)

Name	Meaning
oid	Indicates the MIB object ID of the alarm.
domain-id	Indicates the ID of an RRPP domain.
ring-id	Indicates the ID of an RRPP ring.

The configuration is incorrect. The RRPP ring will fail if it has multiple master nodes.

The RRPP ring had more than one master node. As a result, service traffic is interrupted.

Run the display rrpp verbose domain domain-id command to check whether multiple master nodes exist on the RRPP ring.
- If so, go to Step 2.
- If not, go to Step 3.
Update configurations of the devices that should not be configured as master nodes as follows:
1. Run the undo ring ringid enable command and then the undo ring ringid command to delete configurations of the devices that should not be configured as master nodes. Where, the ringid is the ID of the RRPP ring that has error master nodes.
2. Run the ring ringid node-mode command to reconfigure the master node as required.
3. Run the ring ringid enable command to re-activate the RRPP loop.
After the preceding configurations are complete, check whether the alarm is cleared.
- If so, go to Step 4.
- If not, go to Step 3.
Collect alarm information and configuration information, and then contact technical support personnel.
End.

None