SECE/6/QUEUE_DROP

Message

SECE/6/QUEUE_DROP: Rate of packets to cpu exceeded the QUEUE limit. (SlotId=[STRING], Queue0DropNumber=[STRING], Queue1DropNumber=[STRING], Queue2DropNumber=[STRING], Queue3DropNumber=[STRING], Queue4DropNumber=[STRING], Queue5DropNumber=[STRING], Queue6DropNumber=[STRING], Queue7DropNumber=[STRING])

Description

Some packets in queues sent to the CPU were dropped.

Parameters

Parameter Name	Parameter Meaning
SlotId	On a standalone switch, it specifies a slot ID. On a stacked switch, it specifies a stack ID.
Queue0DropNumber/Queue1DropNumber/Queue2DropNumber/Queue3DropNumber/Queue4DropNumber/Queue5DropNumber/Queue6DropNumber/Queue7DropNumber	Indicates the number of packets dropped in every 10 minutes in queues 0 to 7.

Possible Causes

A large CPCAR value was set for packets to be sent to the CPU. As a result, a large number of packets were sent to the CPU.

Procedure

Run the display cpu-defend configuration slot slot-id command to check whether the CPCAR value configured for each type of protocol packets is correct. The default CPCAR value is recommended.
Collect log information and configuration information, and then contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.