ac-list (AP view)

Function

The ac-list command configures an AC IPv4 address list for APs.

The undo ac-list command restores the AC IPv4 address list to the default value.

By default, no AC IPv4 address list is configured.

Format

ac-list ipv4-address &<1-4>

undo ac-list

Parameters

Parameter	Description	Value
ipv4-address	Specifies the IPv4 address of an AC.	The value is in dotted decimal notation.

Views

AP view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run this command to configure an AC IPv4 address list for APs. After this list is configured, the APs can unicast a Discovery Request packet to discover an AC when they go online using IPv4 addresses.

Precautions

After the configuration is delivered, restart the APs to make the configuration take effect.

Example

# Set the AC's IPv4 address to 192.168.10.1 in the AP view.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-id 0
[HUAWEI-wlan-ap-0] ac-list 192.168.10.1
Warning: The incorrect configuration will cause the AP to go out of management. This operation will deliver parameter setting and ma
y cause reboot of AP(s). Continue?[Y/N]:y