as access interface

Function

The as access interface command specifies source interface for establishing CAPWAP tunnels on an authentication access device.

The undo as access interface command deletes the source interface specified for establishing CAPWAP tunnels from an authentication access device.

By default, no source interface is specified for establishing CAPWAP tunnels on an authentication access device.

Format

as access interface vlanif vlan-id

undo as access interface

Parameters

Parameter	Description	Value
vlanif vlan-id	Specifies a source interface for establishing CAPWAP tunnels.	The value is an integer that ranges from 1 to 4094.

Views

System view

Default Level

3: Management level

Usage Guidelines

Usage Scenario

When the policy association solution is deployed, CAPWAP tunnels are used for connection establishment, user association, message communication, user authorization policy delivery, and user synchronization between authentication control devices and authentication access devices. On an authentication access device, run the as access interface vlanif vlan-id command to specify a source interface for establishing CAPWAP tunnels.

Precautions

This command is supported only on authentication access devices.

The management VLAN of the CAPWAP tunnel cannot be the same as the management VLAN or PnP VLAN of the switches managed by iMaster NCE-Campus.

In policy association, the management VLAN of a CAPWAP tunnel connects authentication access devices to the network. It is not recommended to perform other service configurations except basic configurations in the management VLAN and the corresponding VLANIF interface. If such configurations are performed, authentication access devices may fail to connect to the network.

Example

# Specify a source interface for establishing CAPWAP tunnels.

<HUAWEI> system-view
[HUAWEI] vlan batch 10
[HUAWEI] interface vlanif 10
[HUAWEI-Vlanif10] quit
[HUAWEI] as access interface vlanif 10