clear admin-vrrp
Function
The clear admin-vrrp command deletes the binding of an mVRRP group on the subcard that is not functioning.
Only the S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support this command.
Parameters
| Parameter | Description | Value |
|---|---|---|
interface interface-type interface-number |
Specifies the type and number of an interface where an mVRRP group is configured. |
- |
vrid virtual-router-id |
Specifies the VRID of an mVRRP group. |
The value is an integer that ranges from 1 to 255. |
Usage Guidelines
Usage Scenario
An mVRRP group is often bound to VRRP groups on an interface. If the subcard on which the mVRRP group is configured fails or is not properly installed, the binding is retained and will take effect when the subcard begins working properly. You can run the display vrrp binding admin-vrrp member-vrrp command to check whether configuration recovery is successful.
If the binding is not required, run the clear admin-vrrp command to delete the binding.
Prerequisites
The mVRRP group has been configured and VRRP groups have been bound to the mVRRP group.
Precautions
If the binding between the mVRRP group and VRRP groups is deleted, the status of the mVRRP group no longer determines the status of the bound VRRP groups.
The binding deleted using the clear admin-vrrp command cannot be restored.
Ensure that the interface name is correct when executing the clear admin-vrrp command. This is because the system does not verify the interface name.