clear admin-vrrp6
Function
The clear admin-vrrp6 command deletes the binding of an mVRRP6 group on the member switch that is not functioning in a stack.
Only the S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support this command.
Parameters
| Parameter | Description | Value |
|---|---|---|
| interface interface-type interface-number | Specifies the type and number of an interface where an mVRRP6 group is configured. | - |
| vrid virtual-router-id | Specifies the VRID of an mVRRP6 group. | The value is an integer that ranges from 1 to 255. |
Usage Guidelines
Usage Scenario
In a stack, an mVRRP6 group is often bound to VRRP6 groups on an interface. If the member switch on which the mVRRP6 group is configured fails or is not properly installed, the binding is retained and will take effect when the member switch begins working properly. You can run the display vrrp6 binding admin-vrrp6 member-vrrp command to check whether configuration recovery is successful.
If the binding is not required, run the clear admin-vrrp6 command to delete the binding.
Prerequisites
The mVRRP6 group has been configured and VRRP6 groups have been bound to the mVRRP6 group.
Precautions
If the binding between the mVRRP6 group and VRRP6 groups is deleted, the status of the mVRRP6 group no longer determines the status of the bound VRRP6 groups.
The binding deleted using the clear admin-vrrp6 command cannot be restored.
Ensure that the interface name is correct when executing the clear admin-vrrp6 command. This is because the system does not verify the interface name.