Configuring NetStream Flow Aging

When a NetStream flow is aged out, the device exports the flow statistics in the cache to the NSC using NetStream packets of a specified version.

NetStream flow aging modes include active aging, inactive aging, byte-based aging, and forced aging. By default, the byte-based aging is enabled.

Active aging

This aging mode is enabled on the device by default, and you only need to set the aging time. Active aging requires the device to periodically export statistics about the flows that persist for a long period.
Inactive aging

Inactive aging clears unnecessary entries in the NetStream cache so that the system can fully leverage statistics entries. Inactive aging requires the device to export statistics about the flows that persist for a short period. Once adding packets to a flow stops, the device exports flow statistics to conserve memory space. This aging mode is enabled on the device by default, and you only need to set the aging time.
Forced aging

Forced aging is used when you require the latest statistics, but you do not satisfy with the existing aging conditions or some flows fail to age out due to an anomaly. You can forcibly age out all the original flows in the cache and export the flow statistics.

Configure active aging.
1. Run the system-view command to enter the system view.
2. Run the ip netstream timeout active active-interval command to set the active flow aging time.
  By default, the active flow aging time is 200 seconds.
Configure inactive aging.
1. Run the system-view command to enter the system view.
2. Run the ip netstream timeout inactive inactive-interval command to set the inactive flow aging time.
  By default, the inactive flow aging time is 30 seconds.
Configure forced aging.
1. Run the system-view command to enter the system view.
2. Run the reset ip netstream cache slot slot-id command to forcibly age out all flows in the cache.