Verifying the Martini VPLS Configuration

Prerequisites

All Martini VPLS configurations are complete.

Procedure

Run the display vsi [ name vsi-name ] [ verbose ] command to check information about a VPLS VSI.
Run the display vsi name vsi-name statistics command to check information about VSI statistics, including the PW and AC status.
Run the display l2vpn ccc-interface vc-type { all | vc-type } [ down | up ] command to check information about the interface used by an L2VPN connection.
Run the display vsi remote ldp [ [ router-id ip-address ] [ pw-id pw-id ] | unmatch | verbose ] command to check information about a remote VSI.
Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command to check information about a VPLS connection.
Run the display vpls forwarding-info [ vsi vsi-name [ peer peer-address [ negotiation-vc-id vc-id | remote-site site-id ] ] | state { up | down } ] [ verbose ] command to check forwarding information of all VSIs.
Run the display vsi services { all | vsi-name | interface interface-type interface-number | vlan vlan-id } command to check information about the AC interface associated with the VSI.
Run the display vsi pw out-interface [ vsi vsi-name ] command to check information about the outgoing interface of a PW in a VSI.
Run the display l2vpn vsi-list tunnel-policy policy-name command to check information about the tunnel policy applied to a VSI.
Run the ping vpn-config peer-address peer-address vsi-name vsi-name [ pw-id pw-id ] [ local ] [ remote ] command to check configurations of the VSI on the peer PE.
Run the display mpls label-stack vpls vsi vsi-name peer peer-ip-address vc-id vc-id command to check the information about label stacks in a VPLS scenario.