Configuring Automatic Per Packet Power Adjustment

Context

You can configure automatic per packet power adjustment on WLANs to reduce AP power consumption and interference to surrounding devices. This configuration applies to WLANs with good signal coverage.

Pre-configuration Tasks

Before configuring automatic per packet power adjustment, perform the task of WLAN Service Configuration Guide.

Procedure

Run system-view
The system view is displayed.
Run wlan
The WLAN view is displayed.
Run radio-2g-profile name profile-name or radio-5g-profile name profile-name
The 2G or 5G radio profile view is displayed.
Run power auto-adjust enable
Automatic per packet power adjustment is enabled for APs.

By default, automatic per packet power adjustment is disabled for an AP.
Run quit
Return to the WLAN view.
Bind the radio profile to an AP group or a specific AP. For the detailed procedure, see Binding a Radio Profile.

Verifying the Configuration

Run the display radio-2g-profile name profile-name command to check the automatic per packet power adjustment configuration of an AP in a 2G radio profile.
Run the display radio-5g-profile name profile-name command to check the automatic per packet power adjustment configuration of an AP in a 5G radio profile.