display load-distribution active-linknumber-change

Function

The display load-distribution active-linknumber-change command displays the configuration when the number of interfaces in an Eth-Trunk where load balancing calculation is performed is configured.

Only the S2720-EI, S5720-LI, S5720S-LI, S5720I-SI, S5720-SI, and S5720S-SI support this command.

Format

display load-distribution active-linknumber-change [ interface Eth-Trunk trunk-id ]

Parameters

Parameter	Description	Value
interface Eth-Trunk trunk-id	Specifies the ID of an Eth-Trunk.	The ID of an Eth-Trunk must have been created.

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

After the load-distribution active-linknumber-change command is used to configure the number of interfaces in an Eth-Trunk where load balancing calculation is performed, you can run the display load-distribution active-linknumber-change command to check the configuration.

Example

# Display the configuration when the number of interfaces in an Eth-Trunk where load balancing calculation is performed is configured.

<HUAWEI> display load-distribution active-linknumber-change interface Eth-Trunk 3
-------------------------------------------------------------------------------
Interface    Pre-linknumber    Post-linknumber
-------------------------------------------------------------------------------
Eth-Trunk3       2                  4
-------------------------------------------------------------------------------

**Table 1** Description of the **display load-distribution active-linknumber-change** command output
Item	Description
Interface	Name of the Eth-Trunk.
Pre-linknumber	Number of active interfaces in an Eth-Trunk when the number of interfaces in an Eth-Trunk where load balancing calculation is performed is configured. To configure the number of active interfaces in an Eth-Trunk when the number of interfaces in an Eth-Trunk where load balancing calculation is performed, run the load-distribution active-linknumber-change or load-distribution active-linknumber-change global command.
Post-linknumber	Number of interfaces in an Eth-Trunk where load balancing calculation is performed when the Eth-Trunk has active interfaces. To configure the number of interfaces in an Eth-Trunk where load balancing calculation is performed when the Eth-Trunk has active interfaces, run the load-distribution active-linknumber-change or load-distribution active-linknumber-change global command.