dual-active relay (upgrade-compatible command)

Function

The dual-active relay command enables the relay function on a specified interface of a proxy device.

By default, the relay function is disabled on an interface.

Format

dual-active relay

Parameters

None

Views

Eth-Trunk interface view

Default Level

2: Configuration level

Usage Guidelines

In DAD in relay mode, you need to use the dual-active relay command to configure the relay function on a specified Eth-Trunk interface of a proxy device. Member interfaces of the Eth-Trunk interface forward DAD packets to each other so that member switches can exchange DAD packets.

It is replaced by the mad relay command.

Example

# Enable the relay function on Eth-Trunk 10 of a proxy device.

<HUAWEI> system-view
[HUAWEI] interface eth-trunk 10
[HUAWEI-Eth-Trunk10] dual-active relay