fwa wmm edca-mode

Function

The fwa wmm edca-mode command sets the Enhanced Distributed Channel Access (EDCA) mode.

By default, the automatic EDCA mode is used.

Format

fwa wmm edca-mode { auto | manual }

Parameters

Parameter	Description	Value
auto	Sets the EDCA mode to auto. In automatic EDCA mode, ATs automatically adjust EDCA parameters based on the number of ATs connecting to the remote AP.	-
manual	Sets the EDCA mode to manual. In manual mode, you can run the fwa wmm edca-client command to configure EDCA parameters of the AT. The remote AP negotiates with the AT according to the configured parameters.	-

Parameter

Description

Value

auto

Sets the EDCA mode to auto.

In automatic EDCA mode, ATs automatically adjust EDCA parameters based on the number of ATs connecting to the remote AP.

manual

Sets the EDCA mode to manual.

In manual mode, you can run the fwa wmm edca-client command to configure EDCA parameters of the AT. The remote AP negotiates with the AT according to the configured parameters.

Views

Mesh profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

In scenarios where the AT connects to the remote AP through Mesh links, ATs automatically adjust EDCA parameters based on the number of ATs connecting to the remote AP. In manual mode, you can run the fwa wmm edca-client command to configure EDCA parameters of the AT. The remote AP negotiates with the AT according to the configured parameters.

The fwa wmm edca-mode command takes effect only after the FWA mode is enabled in the Mesh profile using the fwa enable command.
In automatic EDCA mode, the EDCA parameters manually configured using the fwa wmm edca-client command do not take effect on the AP.
This command applies only to scenarios where the AT connects to the remote AP through Mesh links.

Example

# Set the EDCA mode to auto.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] mesh-profile name huawei
[HUAWEI-wlan-mesh-prof-huawei] fwa wmm edca-mode auto