interface-parameter-type vccv (VSI-LDP-PW view)

Function

The interface-parameter-type vccv command restores the default setting.

The undo interface-parameter-type vccv command deletes the VCCV byte right after the interface parameter in the Mapping packet.

By default, a mapping packet carries the VCCV byte.

Format

interface-parameter-type vccv

undo interface-parameter-type vccv

Parameters

None

Views

VSI-LDP-PW view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If the switch communicates with the devices of VRP V300R001 and all branching versions, and the LDP VPLS is configured, run the undo interface-parameter-type vccv command.

Prerequisites

The following operations have been performed before this command is used:

LDP has been configured as the PW signaling protocol using the pwsignal ldp command.
The VSI ID has been configured using the vsi-id vsi-id command.
The peer of the VSI has been configured using the peer peer-address command.
The PW has been configured using the peer peer-address [ negotiation-vc-id vc-id ] pw pw-name command.

Example

# When configuring the VPLS in LDP mode, delete the VCCV byte from the Mapping packet.

<HUAWEI1> system-view
[HUAWEI] vsi vsi1 static
[HUAWEI-vsi-vsi1] pwsignal ldp
[HUAWEI-vsi-vsi1-ldp] vsi-id 100
[HUAWEI-vsi-vsi1-ldp] peer 2.2.2.2
[HUAWEI-vsi-vsi1-ldp] peer 2.2.2.2 pw pw1
[HUAWEI-vsi-vsi1-ldp-pw-pw1] undo interface-parameter-type vccv