The ip source check user-bind alarm enable command enables the alarm function of IP packet check.
The undo ip source check user-bind alarm enable command disables the alarm function of IP packet check.
By default, the alarm function of IP packet check is disabled.
VLAN view, Ethernet interface view, GE interface view, XGE interface view, 25GE interface view, MultiGE interface view, 40GE interface view, 100GE interface view, Eth-Trunk interface view, port group view
Usage Scenario
The ip source check user-bind alarm enable command enables the log and alarm function for IP packet check. If the number of discarded packets reaches the threshold, the device sends an alarm to the NMS device.
Prerequisites
IP packet check has been enabled using the ip source check user-bind enable command on the interface.
Follow-up Procedure
Run the ip source check user-bind alarm threshold command to set the alarm threshold.
Precautions
If the alarm function of IP packet check is enabled both in the VLAN view and in the view of the interface added to the VLAN, it takes effect in the view where it was first enabled. To change the order in which the function takes effect, disable it in the view where it has taken effect, and then enable it in the desired view.