ip source check user-bind alarm threshold

Function

The ip source check user-bind alarm threshold command sets the alarm threshold for IP packet check.

The undo ip source check user-bind alarm threshold command restores the default alarm threshold for IP packet check.

By default, the alarm threshold is 100.

Format

ip source check user-bind alarm threshold threshold

undo ip source check user-bind alarm threshold

Parameters

Parameter	Description	Value
threshold	Specifies an alarm threshold for IP packet check.	The value is an integer that ranges from 1 to 1000.

Views

VLAN view, Ethernet interface view, GE interface view, XGE interface view, 25GE interface view, MultiGE interface view, 40GE interface view, 100GE interface view, Eth-Trunk interface view, port group view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After the alarm function of IP packet check is enabled, run the ip source check user-bind alarm threshold command to set the alarm threshold for IP packet check.

Prerequisites

The alarm function of IP packet check has been enabled using the ip source check user-bind alarm enable command.

Example

# Set the alarm threshold for IP packet check to 200 on GE0/0/1.

<HUAWEI> system-view

[HUAWEI] interface gigabitethernet 0/0/1

[HUAWEI-GigabitEthernet0/0/1] ip source check user-bind enable

[HUAWEI-GigabitEthernet0/0/1] ip source check user-bind alarm enable

[HUAWEI-GigabitEthernet0/0/1] ip source check user-bind alarm threshold 200