iplpm link loss-measure enable

Function

The iplpm link loss-measure enable command enables packet loss measurement on the direct link.

The undo iplpm link loss-measure enable command disables packet loss measurement on the direct link.

By default, packet loss measurement is disabled on the direct link.

Format

iplpm link loss-measure enable

undo iplpm link loss-measure enable

Parameters

None

Views

GE interface view, XGE interface view, MultiGE interface view, 25GE interface view, 40GE interface view, 100GE interface view

Default Level

2: Configuration level

Usage Guidelines

To accurately locate packet loss on a link, run the iplpm link loss-measure enable command to enable packet loss measurement on the direct link between two devices.

This function must be enabled on both device interfaces of the direct link.

Example

# On the GE0/0/1, enable packet loss measurement on the direct link.

<HUAWEI> system-view
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] iplpm link loss-measure enable