led blink-time

Function

The led blink-time command configures the indicator blinking function for an AP.

The undo led blink-time command cancels the indicator blinking configuration of an AP.

By default, the indicator blinking function is disabled on an AP.

Format

led blink-time blink-time { ap-mac ap-mac | ap-name ap-name | ap-id ap-id }

undo led blink-time { ap-mac ap-mac | ap-name ap-name | ap-id ap-id | all }

Parameters

Parameter	Description	Description
blink-time	Specifies the blinking time of an AP.	The value is an integer that ranges from 1 to 86400, in seconds.
ap-mac ap-mac	Specifies the MAC address of an AP.	The value is in H-H-H format. An H is a hexadecimal number of 4 digits.
ap-name ap-name	Specifies the AP name.	The AP name must exist.
ap-id ap-id	Specifies the AP ID.	The AP ID must exist.
all	Cancels the indicator blinking configuration of all APs.	-

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Application Scenario

To locate an AP, run this command on the AC to configure the AP indicator to blink.

When this function is enabled, the SYS indicator blinks red if an AP runs V200R019C10 or later, and blinks orange and green alternatively if the AP runs V200R019C00 or earlier.

Precautions

Offline APs cannot be located by configuring the AP indicator to blink.

The configuration using the led blink-time command takes precedence over that using the led off command. That is, if AP indicators are configured to blink and to turn off or turn off during the specified time range, the configuration performed using the led off command takes effect after the RU indicators blink.

This function is not available for central APs.

Example

# Configure the indicator of an AP with the MAC address of 0025-9e07-8260 to blink for 300 seconds.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] led blink-time 300 ap-mac 0025-9e07-8260