lldp admin-status

Function

The lldp admin-status command sets the LLDP operation mode for an AP.

The undo lldp admin-status command restores the default LLDP operation mode for an AP.

By default, the LLDP operation mode of an AP is TxRx.

Format

lldp admin-status { rx | tx | txrx }

undo lldp admin-status

Parameters

Parameter	Description	Value
rx	Specifies the LLDP operation mode as Rx. An AP only receives but does not send LLDP packets.	-
tx	Specifies the LLDP operation mode as Tx. An AP only sends but does not receive LLDP packets.	-
txrx	Specifies the LLDP operation mode as TxRx. An AP sends and receives LLDP packets.	-

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

You can configure the LLDP operation mode for an AP based on the site requirements. For example, if you set the LLDP operation mode of an AP to Tx, the AP sends LLDP packets but cannot receive LLDP packets from neighbors. In this situation, the AP cannot discover neighbors.

Example

# Set the LLDP operation mode of an AP to Tx.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name ap-system1
[HUAWEI-wlan-ap-system-prof-ap-system1] lldp admin-status tx