monitor input

Function

The monitor input command configures the name and normal level of the input lines connected to a monitoring interface.

The undo monitor input command restores the name and normal level of the input lines connected to a monitoring interface to default value.

By default, the name of a monitored input line is Input1 or Input2. The normal level is low-level.

Only the S5720I-SI (except S5720I-6X-PWH-SI-AC and S5720I-10X-PWH-SI-AC) supports this command.

Format

monitor input line-id name line-name normal-state { low-level | high-level } [ slot slot-id ]

undo monitor input line-id [ slot slot-id ]

Parameters

Parameter	Description	Value
line-id	Specifies the ID of an input line.	The value is an integer that ranges from 1 to 2.
name line-name	Specifies the name of an input line.	The name is a string of 1 to 31 case-sensitive characters without spaces.
normal-state { low-level \| high-level }	Specifies the normal level of input lines connected to a monitoring interface. low-level: indicates that the normal level is low level. high-level: indicates that the normal level is high level.	-
slot slot-id	Specifies the stack ID if stacking is configured.	The value is determined based on the device configuration.

Views

System view

Default Level

2: Configuration level

Usage Guidelines

You can run the monitor input command to configure the name and normal level of the input lines connected to a monitoring interface. When the level of the input line changes, the device generates an alarm.

Example

# Configure the name of input line 1 as line1 and normal level as high-level.

<HUAWEI> system-view
[HUAWEI] monitor input 1 name line1 normal-state high-level