qos phb marking enable

Function

The qos phb marking enable command enables PHB mapping for outgoing packets on an interface.

The undo qos phb marking enable command disables PHB mapping for outgoing packets on an interface.

By default, PHB mapping is enabled for outgoing packets on an interface.

Only the S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S5735-L, S5735S-L, S5735S-L-M, S5735-S, S5735-S-I, S5735S-S, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support this command.

Format

qos phb marking enable

undo qos phb marking enable

Parameters

None

Views

GE interface view, XGE interface view, MultiGE interface view, 25GE interface view, 40GE interface view, 100GE interface view, Eth-Trunk interface view, port group view

Default Level

2: Configuration level

Usage Guidelines

Scenario

After the undo qos phb marking enable command is executed on the interface of the edge node in a DiffServ domain, PHB mapping is disabled on the interface connected to a device that does not belong to the DiffServ domain.

Precautions

The trust upstream none command is executed to disable PHB mapping on an interface. After the trust upstream none command is executed, the system does not perform PHB mapping for incoming and outgoing packets on the interface. Unlike the trust upstream none command, after the undo qos phb marking enable command is executed, the system does not perform PHB mapping for outgoing packets on the interface but performs PHB mapping for incoming packets on the interface.
The undo qos phb marking enable and trust upstream none commands cannot be executed simultaneously.

Example

# Disable PHB mapping for outgoing packets on GigabitEthernet0/0/1.

<HUAWEI> system-view
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] undo qos phb marking enable