reset cloud-mng work-mode

Since V200R019C00, you no longer need to change the working mode of a switch to cloud-mng to implement cloud-based management. Instead, you can enable NETCONF on the switch to implement cloud-based management. However, after a switch working in cloud-mng mode is upgraded from an earlier version to V200R019C10 or a later version, the cloud-based management flag still exists in the flash memory of the switch. As a result, the LNP, VCMP, and OPS functions do not take effect.

To resolve this problem, run the reset cloud-mng work-mode command to clear the cloud-based management flag in the flash memory of the switch.

• When you run the undo netconf command on a switch that originally worked in cloud-mng mode before the upgrade, the following message is displayed to prompt you to run the reset cloud-mng work-mode command to restore the LNP, VCMP, and OPS functions:

  Info: After the device is upgraded in cloud management mode, execute 'reset cloud-mng work-mode' to restore the LNP, VCMP, and OPS functions.

  When you run the reset cloud-mng work-mode command, the switch displays the following message indicating that this operation will delete the saved configuration and the device will restart. Exercise caution when performing this operation.

  Warning: The action will delete the saved configuration and reboot. Continue? [Y/N]:

• When you run the reset cloud-mng work-mode command on a switch that did not work in cloud-mng mode before the upgrade, the following message is displayed indicating that this operation is not required:

  Info: Current status is not upgrade from Cloud-mng mode.