responder

Function

The responder command enables the TWAMP Light Responder function and displays the TWAMP-Light-Responder view. If the Responder function has been enabled, the TWAMP-Light-Responder view is directly displayed.

The undo responder command disables the TWAMP Light Responder function.

By default, the TWAMP Light Responder function is disabled.

Format

responder

undo responder

Parameters

None

Views

TWAMP-Light view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

To use the TWAMP Light service, run the Responder command on the Responder to display the TWAMP-Light-Responder view and create a measurement session. Then the Controller starts the measurement service based on the session configuration.

Precautions

After the TWAMP Light Responder is deleted, the packet loss rate is displayed as 100%, which is inaccurate.

Example

# Enable the TWAMP Light Responder function.

<HUAWEI> system-view
[HUAWEI] nqa twamp-light
[HUAWEI-twamp-light] responder
[HUAWEI-twamp-light-responder]