set device port-config-mode 100g-port enable
Function
The set device port-config-mode 100g-port enable command configures the 100GE interface working mode of the panel.
The undo set device port-config-mode 100g-port enable command restores the default panel interface working mode.
By default, a switch can only work in 10GE and 40GE interface working modes.
- 44*10GE + 2*100GE + 4*40GE
(The switch can work in 100GE interface working mode.)
- 48*10GE + 6*40GE
(The switch can only work in 10GE and 40GE working modes.)
Format
set device port-config-mode 100g-port enable [ slot slot-id ]
undo set device port-config-mode 100g-port enable [ slot slot-id ]
Parameters
Parameter |
Description |
Value |
|---|---|---|
slot slot-id |
Specifies the slot ID. |
The value depends on the device configuration. |
Usage Guidelines
Usage Scenario
By default, the 10GE and 40GE interface working modes are configured on the panel of a switch, and 48 10GE interfaces and six 40GE interfaces are supported (48*10GE + 6*40GE). If high-speed 100GE interfaces need to be used, you can run the set device port-config-mode 100g-port enable command. In this case, 44 10GE interfaces, two 100GE interfaces, and four 40GE interfaces are supported on the panel (44*10GE + 2*100GE + 4*40GE).
Precautions
After running this command, you must confirm operations as prompted so that the switch automatically restarts to make the configuration take effect. Save the configuration in advance.