set device port-config-mode port-on-board enable
Function
The undo set device port-config-mode port-on-board enable command configures the card interface working mode.
The set device port-config-mode port-on-board enable command restores the panel interface working mode.
By default, a switch works in the panel interface working mode.
Only S6720-C-SI series switches support this command.
Format
set device port-config-mode port-on-board enable [ slot slot-id ]
undo set device port-config-mode port-on-board enable [ slot slot-id ]
Parameters
Parameter |
Description |
Value |
|---|---|---|
slot slot-id |
Specifies the slot ID. |
The value depends on the device configuration. |
Usage Guidelines
Usage Scenario
S6720-C-SI series switches support extended cards. However, the four 10GE SFP+ Ethernet optical interfaces on the front panel and interfaces on the extended cards (excluding the 4*10GE card) cannot be used simultaneously. By default, a switch uses interfaces on the panel. To use interfaces on a card, run the undo set device port-config-mode port-on-board enable command to configure the card interface working mode. Interfaces on the panel then cannot be used.
Precautions
When a 4*10GE card is installed, both interfaces on the card and panel can be used.
After running this command, you must confirm operations as prompted so that the switch automatically restarts to make the configuration take effect. Save the configuration in advance.
When the panel interface working mode is changed to the card interface working mode, the four 10GE SFP+ Ethernet optical interfaces on the front panel cannot be used. After the save command is run, the configuration of the four 10GE SFP+ Ethernet optical interfaces on the front panel will be cleared. This applies to the interfaces on the card similarly when the card interface working mode is changed to the panel interface working mode.