spectrum-analysis server

Function

The spectrum-analysis server command specifies the IP address and port number of a spectrum server.

The undo spectrum-analysis server command deletes the specified IP address and port number of a spectrum server.

By default, no spectrum server is configured.

Format

spectrum-analysis server ip-address ip-address port port-number [ via-ac ac-port ac-port-number ]

undo spectrum-analysis server

Parameters

Parameter	Description	Value
ip-address ip-address	Specifies the IPv4 address of a spectrum server.	The value is in dotted decimal notation.
port port-number	Specifies the port number (UDP port number) of a spectrum server.	The value is an integer that ranges from 1 to 65535. NOTE: The port number of eSight is 32181.
via-ac	Configures the AP to report spectrum data to the spectrum server via the AC.	-
ac-port ac-port-number	Specifies the port number used by the AC to receive spectrum data (in UDP packets) from the AP.	The value is an integer that ranges from 5000 to 65535.

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After collecting the spectrum data, an AP encapsulates the collected data into UDP packets and sends the packets to the spectrum server. The spectrum server draws a spectrum and displays the spectrum information of the detected non-Wi-Fi devices to users through images.

If the AP uploads the collected data directly to the spectrum server, you do not need to configure the via-ac ac-port ac-port-number command.
If the AP uploads the collected data to the spectrum server via the AC, configure the via-ac ac-port ac-port-number command.
If no spectrum server is available, to view the spectrum in the web system of an AC, specify a valid IP address and port number for the spectrum server (The specified values do not take effect.) and configure the via-ac ac-port ac-port-number command.

Follow-up Procedure

Run the spectrum-report { ap-name ap-name | ap-id ap-id } radio radio-id command to enable the function of reporting spectrum data on an AP radio.

Example

# Set the IP address and port number of a spectrum server to 10.137.43.4 and 32181.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-system-profile name ap-system1
[HUAWEI-wlan-ap-system-prof-ap-system1] spectrum-analysis server ip-address 10.137.43.4 port 32181