spectrum-analysis source

Function

The spectrum-analysis source command configures the source IP address of packets sent by an AC to a spectrum server.

The undo spectrum-analysis source command deletes the configured source IP address of packets sent by an AC to a spectrum server.

By default, an AC uses the IP address of the outbound interface on the matched route as the source IP address of packets sent to a spectrum server.

Format

spectrum-analysis source ip-address ip-address

undo spectrum-analysis source

Parameters

Parameter	Description	Value
ip-address ip-address	Specifies the source IPv4 address of packets sent by an AC to a spectrum server.	The value is in dotted decimal notation.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

By default, when sending data packets to a spectrum server, an AC uses the IP address of the outbound interface on the matched route between them to communicate with the spectrum server.

After the source IP address is configured using the spectrum-analysis source command, the AC uses this IP address to communicate with the spectrum server.

Precautions

Ensure that the AC's IP address manually configured on the spectrum server is the same as that configured using the spectrum-analysis source command.
The configured source IP address must exist on the AC and is routable with the spectrum server.

Example

# Configure 10.102.25.23 as the source IP address of packets sent by the AC to a spectrum server.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] spectrum-analysis source ip-address 10.102.25.23