sta-load-balance dynamic probe-report interval

Function

The sta-load-balance dynamic probe-report interval command sets the interval for reporting Probe frames.

The undo sta-load-balance dynamic probe-report interval command restores the default interval for reporting Probe frames.

By default, Probe frames are reported at an interval of 120 seconds.

Format

sta-load-balance dynamic probe-report interval interval

undo sta-load-balance dynamic probe-report interval

Parameters

Parameter	Description	Value
interval	Specifies the interval for reporting Probe frames.	The value is an integer that ranges from 30 to 300, in seconds.

Views

RRM profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After an AP receives information about neighboring APs of STAs, it reports the information to the AC for determining the target APs to which the STAs will roam. You can run the sta-load-balance dynamic probe-report interval command to set the interval at which the AP reports information about neighboring APs of the STAs.

Precautions

You are advised to retain the default value. If the device has high performance pressure, you can set a longer interval.

Example

# Set the interval for reporting Probe frames to 125 seconds in RRM profile default.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] rrm-profile name default
[HUAWEI-wlan-rrm-prof-default] sta-load-balance dynamic probe-report interval 125