ipfpm tlp

Function

The ipfpm tlp command binds a Target Logical Port (TLP) to an interface in a measurement instance on a DCP.

The undo ipfpm tlp command unbinds a TLP from an interface in a measurement instance on a DCP.

By default, an interface is not bound to a TLP in a measurement instance on a DCP.

Format

ipfpm tlp tlp-id

undo ipfpm tlp { tlp-id | all }

Parameters

Parameter	Description	Value
tlp-id	Specifies the ID of a TLP.	The value is an integer that ranges from 1 to 16777215.
all	Cancels the binding between all TLPs and interfaces.	-

Views

GE interface view, XGE interface view, MultiGE interface view, 25GE interface view, 40GE interface view, 100GE interface view, Eth-Trunk interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Before performing packet loss measurement, run this command to bind a TLP to an interface.

Prerequisites

A Layer 2 or Layer 3 interface can be bound to a TLP. You can run the undo portswitch command to switch the interface to Layer 3 mode.

Precautions

A TLP can be bound to only one interface on the DCPs associated with an MCP, and an interface can bound only one TLP.

Example

# Bind GE0/0/1 to TLP 100.

<HUAWEI> system-view
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] undo portswitch
[HUAWEI-GigabitEthernet0/0/1] ipfpm tlp 100