uni-mng indirect mng-vlan
Function
The uni-mng indirect mng-vlan command configures a device to work in client mode and configures a management VLAN.
This command can only be executed on an AS.
Parameters
| Parameter | Description | Value |
|---|---|---|
vlan-id |
Specifies a management VLAN. The VLAN must be consistent with the management VLAN configured on a parent. |
The value is an integer that ranges from 2 to 4094. The VLAN cannot be the reserved VLAN (The default is VLAN 4093) of a stack. |
Usage Guidelines
Usage Scenario
When an AS connects to the parent through a network, you must run the uni-mng indirect mng-vlan command to configure the AS to work in client mode and configures a management VLAN.
Precautions
The VCMP role switching command is mutually exclusive with the command that configures a device to work in client mode. If the current device is not a silent switch in a VCMP domain, the device cannot be configured to work in client mode. You must run the vcmp role silent command in the system view to set the VCMP role of the device to silent. After a device is configured to work in client mode, the VCMP role switching command cannot be executed. That is, the device cannot change from the silent role to another role.
After running the uni-mng indirect mng-vlan vlan-id command on the device in standalone mode, you must delete the configuration file of the device and restart the device to make the configuration take effect.
If the device has been configured to work in client mode but has not gone online, you can run the uni-mng indirect mng-vlan vlan-id command multiple times to change the management VLAN, and the configuration takes effect immediately.
If the device has been configured to work in client mode and has gone online, the uni-mng indirect mng-vlan vlan-id command cannot be executed.
When an AS is an S5700-10P-LI, S5700-10P-PWR-LI-AC, or S2750-EI and Layer 3 hardware forwarding for IPv4 packets has been enabled using the assign forward-mode ipv4-hardware command in the system view, the management VLAN cannot be configured. To solve this problem, start the AS in standalone mode and run the undo assign forward-mode command in the system view to disable Layer 3 hardware forwarding for IPv4 packets.
On the S5720-SI, S5735-S, S5735S-S, S5720S-SI, S5720I-SI, S5730-SI, S5730S-EI, S6720-LI, S6720S-LI, S6720-SI, S6720S-SI, S600-E, the electrical port stack configuration on the front panel is mutually exclusive with the client mode configuration. If electrical ports on the front panel have been configured as stack physical member ports, no management VLAN cannot be configured. If a management VLAN has been configured, electrical ports on the front panel cannot be configured as stack physical member ports.
- If an AS is configured in the independent mode, its management VLAN cannot be configured using this command.
- The slot ID of an AS cannot be greater than or equal to 5. Otherwise, the management VLAN cannot be configured for the AS using the uni-mng indirect mng-vlan command.
- The command that changes a stack ID and the command that configures a management VLAN are mutually exclusive.
- The management VLAN cannot be configured for an AS after the slot ID of the AS is changed using the stack slot slot-id renumber new-slot-id command.
- The slot ID of an AS cannot be changed using the stack slot slot-id renumber new-slot-id command after a management VLAN is configured for the AS using the uni-mng indirect mng-vlan command.