user-access-port enable (network enhanced profile view)

Function

The user-access-port enable command configures the edge port function in a network enhanced profile.

The undo user-access-port enable command cancels the edge port function in a network enhanced profile.

By default, the edge port function is not configured in a network enhanced profile.

This command can only be executed on a parent switch.

Format

user-access-port enable

undo user-access-port enable

Parameters

None

Views

Network enhanced profile view

Default Level

3: Management level

Usage Guidelines

After creating a network enhanced profile, you can configure the edge port function in the profile. After the profile is bound to an AS port, the port becomes an edge port. The following configuration is generated on the AS port:

#
 stp edged-port enable
#

Ports connected to a Layer 2 STP network do not need to participate in spanning tree calculation. If these ports participate in the calculation, the network topology convergence speed is affected and the status changes of these ports may cause network flapping. After these ports are configured as edge ports, they do not participate in spanning tree calculation. This configuration speeds up network topology convergence and enhances network stability.

Example

# Enable the edge port function in a network enhanced profile.

<HUAWEI> system-view
[HUAWEI] uni-mng
[HUAWEI-um] network-enhanced-profile name profile_1
[HUAWEI-um-net-enhanced-profile_1] user-access-port enable