vcmp disable

Function

The vcmp disable command disables VCMP on an interface.

The undo vcmp disable command enables VCMP on an interface.

By default, VCMP is enabled on all interfaces of a switch.

Format

vcmp disable

undo vcmp disable

Parameters

None

Views

Ethernet interface view, GE interface view, XGE interface view, 25GE interface view, 100GE interface view, 40GE interface view, MultiGE interface view, Eth-Trunk interface view, port group view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

By default, VCMP is enabled on all interfaces of a switch. If an edge switch in a VCMP domain requires VCMP management but its peer end does not require VCMP management, run the vcmp disable command on the edge switch Layer 2 interface connected to the peer end to disable VCMP. The peer end then does not receive VCMP packets.

Prerequisites

The interface connected to the peer end has been configured as a Layer 2 interface using the portswitch command.

Example

# Disable VCMP on GE0/0/1.

<HUAWEI> system-view

[HUAWEI] interface gigabitethernet 0/0/1

[HUAWEI-GigabitEthernet0/0/1] vcmp disable