DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.5 hwEntityReset-66576

Trap Buffer Description

Physical entity reset. (EntityPhysicalIndex=[ULONG],BaseTrapSeverity=4, BaseTrapProbableCause=66576, BaseTrapEventType=5, EntityPhysicalIndex=[ULONG], EntPhysicalContainedIn=[ULONG], EntPhysicalName=[STRING], RelativeResource=[STRING], ReasonDescription=Because of heart beat loss, the entity of %s is resetting, not ready.)

The physical entity reset because a part failed.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Alert
Mnemonic Code	hwEntityReset
Trap OID	1.3.6.1.4.1.2011.5.25.129.2.1.5
MIB	HUAWEI-BASE-TRAP-MIB
Alarm ID	0x08130094
Alarm Name	hwEntityReset
Alarm Type	equipmentAlarm
Raise or Clear	Raise
Match trap	DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.6 hwEntityResetDone-66576

Trap Buffer Parameters

Parameter	Description
BaseTrapSeverity	Indicates the physical index.
BaseTrapProbableCause	Possible reason.
BaseTrapEventType	Indicates the possible cause of the trap.
EntityPhysicalIndex	Indicates the trap type.
EntPhysicalContainedIn	Indicates the parent index.
EntPhysicalName	Indicates the name of the entity such as a chassis.
RelativeResource	This object may contain a key word to indicate the relative resource of an entity.
ReasonDescription	To describe the reason of trap in DisplayString style.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.129.1.1	hwBaseTrapSeverity	-
1.3.6.1.4.1.2011.5.25.129.1.2	hwBaseTrapProbableCause	-
1.3.6.1.4.1.2011.5.25.129.1.3	hwBaseTrapEventType	-
1.3.6.1.2.1.47.1.1.1.1.4	entPhysicalContainedIn	entPhysicalIndex
1.3.6.1.2.1.47.1.1.1.1.7	entPhysicalName	entPhysicalIndex
1.3.6.1.4.1.2011.5.25.129.1.4	hwBaseTrapRelativeResource	-
1.3.6.1.4.1.2011.5.25.129.1.5	hwBaseTrapReasonDescr	-

Impact on the System

The interface board will be reset and cause packet loss.

Possible Causes

Cause 1: A fault may occur on the ECM channel.

Cause 2: The CPU usage on the master MPU is too high.

Procedure

1. The interface board can be reset automatically. After the reset, run the display device command to check whether the interface board works normally.

If so, go to Step 4.
If not, go to Step 2.

2. Replace the interface board and then check whether the fault is rectified.

If so, go to Step 4.
If not, go to Step 3.

3. Collect the trap information, log information, and configuration of the router, and contact technical support personnel.

4. End.