DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.9 hwEntityInvalid-68148

Trap Buffer Description

Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[68148], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=The link-heartbeat detection packet was dropped on the link.)

Physical entity failed.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Alert
Mnemonic Code	hwEntityInvalid
Trap OID	1.3.6.1.4.1.2011.5.25.129.2.1.9
MIB	HUAWEI-BASE-TRAP-MIB
Alarm ID	0x08130055
Alarm Name	hwEntityInvalid
Alarm Type	equipmentAlarm
Raise or Clear	Raise
Match trap	DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.10 hwEntityResume-68148

Trap Buffer Parameters

Parameter	Description
BaseTrapSeverity	To describe the level of trap.
ProbableCause	To describe the probable cause of trap.
BaseTrapEventType	To describe the type of trap.
EntityPhysicalIndex	The index of the physical entity.
EntContainedIn	The value of entPhysicalIndex for the physical entity.
EntPhysicalName	The textual name of the physical entity.
RelativeResource	This object may contain a key word to indicate the relative resource of an entity.
ReasonDescription	To describe the reason of trap in DisplayString style.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.129.1.1	hwBaseTrapSeverity	-
1.3.6.1.4.1.2011.5.25.129.1.2	hwBaseTrapProbableCause	-
1.3.6.1.4.1.2011.5.25.129.1.3	hwBaseTrapEventType	-
1.3.6.1.2.1.47.1.1.1.1.4	entPhysicalContainedIn	entPhysicalIndex
1.3.6.1.2.1.47.1.1.1.1.7	entPhysicalName	entPhysicalIndex
1.3.6.1.4.1.2011.5.25.129.1.4	hwBaseTrapRelativeResource	-
1.3.6.1.4.1.2011.5.25.129.1.5	hwBaseTrapReasonDescr	-

Impact on the System

The link-heartbeat linkage packet-modify enable command run in the slot view may lead to operations, such as interface shutdown, subcard resetting, and board resetting. After such operations are performed, if the alarm persists, a hardware fault occurs, which may cause packets to be modified. This problem needs to be solved immediately.

Possible Causes

The link-heartbeat detection packet was dropped on the link.

Procedure

1. Run the power off slot slot-id and power on slot slot-id commands on the boards at both ends of the direct link. After the boards are registered, check whether the alarm is cleared.

If so, go to Step 4.
If not, go to Step 2.

2. Replace the board, and then check whether the alarm is cleared.

If so, go to Step 4.
If not, go to Step 3.

3. Collect trap, log, and configuration information, and contact technical support.

4. End.