LACP_1.3.6.1.4.1.2011.5.25.41.3.2 hwLacpNegotiateFailed

Trap Buffer Description

The member of LAG can neither receive PDUs nor send PDUs. (TrunkIndex=[TrunkIndex], PortIfIndex=[PortIfIndex], TrunkId=[TrunkId], TrunkName=[TrunkName], PortName=[PortName], Reason=[ReasonCode])

Negotiations over member links failed.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Critical
Mnemonic Code	hwLacpNegotiateFailed
Trap OID	1.3.6.1.4.1.2011.5.25.41.3.2
MIB	HUAWEI-IF-EXT-MIB
Alarm ID	0x09360000
Alarm Name	hwLacpNegotiateFailed
Alarm Type	communicationsAlarm
Raise or Clear	Raise
Match trap	LACP_1.3.6.1.4.1.2011.5.25.41.3.13 hwLacpNegotiateResume

Trap Buffer Parameters

Parameter	Description
TrunkIndex	Index of a trunk
PortIfIndex	Index of a member interface
TrunkId	ID of a trunk interface
TrunkName	Name of a trunk interface
PortName	Name of a member interface
ReasonCode	Reason for trap generation

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.41.1.3.3.1.2	hwTrunkIfID	hwTrunkIndex
1.3.6.1.2.1.31.1.1.1.1	ifName	ifIndex
1.3.6.1.2.1.31.1.1.1.1	ifName	ifIndex

Impact on the System

The link cannot transmit services.

Possible Causes

A link fault occurred or negotiation information synchronization failed.

Procedure

1. Run the display this command in the interface view to check whether the local or remote interface is shut down.

If either interface is shut down, run the undo shutdown command to enable the interface, and then check whether the alarm is cleared. If the alarm is not cleared, go to Step 2.
If no interface is shut down, go to Step 2.

2. Check whether the physical link of the interface works improperly. That is, check whether the hardware such as the network cable or optical module is disconnected or loosely connected.

If the physical link works improperly, you need to correctly connect the physical link and then check whether the alarm is cleared. If the alarm is not cleared, go to Step 3.
If the physical link works properly, go to Step 3.

3. Run the display interface eth-trunk command in the system view to check whether a local or remote interface is removed from an Eth-Trunk.

If the interface is incorrectly removed from the Eth-Trunk, run the eth-trunk command in the member interface view or the trunkport command in the Eth-Trunk interface view to re-add the interface to the Eth-Trunk, and then check whether the alarm is cleared. If the alarm is not cleared, go to Step 4.
If the interface is correctly removed from the Eth-Trunk, go to Step 4.

4. Collect the alarm, log, and configuration information, and contact technical support personnel.