The card failed partially. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityType=[EntityType], EntityTrapFaultID=135168, Reason=The monitoring channel of the subcard was faulty.)
The subcard experienced a partial failure.
In VS mode, this trap is supported only by the admin VS.
| Trap Attribute | Description |
|---|---|
Alarm or Event |
Alarm |
Trap Severity |
Alert |
Mnemonic Code |
hwCardFail |
Trap OID |
1.3.6.1.4.1.2011.5.25.219.2.3.3 |
MIB |
HUAWEI-ENTITY-TRAP-MIB |
Alarm ID |
0x08130056 |
Alarm Name |
hwCardFail |
Alarm Type |
equipmentAlarm |
Raise or Clear |
Raise |
Match trap |
| Parameter | Description |
|---|---|
EntityPhysicalIndex |
Indicates the index of the physical entity. |
EntPhysicalIndex |
Indicates the index of the physical entity. |
EntityTrapFaultID |
Indicates the error code. |
EntPhysicalName |
Indicates the name of the physical entity. |
EntityType |
Indicates the type of the physical entity. |
Reason |
Indicates the description of the cause of the trap. |
| VB OID | VB Name | VB Index |
|---|---|---|
1.3.6.1.4.1.2011.5.25.219.1.1 |
hwEntityPhysicalIndex |
- |
1.3.6.1.2.1.47.1.1.1.1.7 |
entPhysicalName |
entPhysicalIndex |
1.3.6.1.4.1.2011.5.25.219.1.2 |
hwEntityTrapEntType |
- |
1.3.6.1.4.1.2011.5.25.219.1.3 |
hwEntityTrapFaultID |
- |
1.3.6.1.4.1.2011.5.25.219.1.13 |
hwEntityTrapReasonDescr |
- |
1.3.6.1.4.1.2011.5.25.31.1.1.1.1.2 |
hwEntityOperStatus |
entPhysicalIndex |
1. Services will not be affected, but a solution is required because the temperature and voltage of the subcard cannot be monitored and the EEPROM cannot be accessed.
2. Services will not be affected, but a solution is required because the subcard cannot be plugged in and out.
3. Services will not be affected, but a solution is required because the temperature and voltage of the subcard cannot be monitored.
4. Services will not be affected, but a solution is required because the subcard reset function cannot be enabled.
1. Power off the subcard and then power it on again. Check if the alarm is cleared.
2. Collect alarm information, log information and configuration information, and then contact technical support personnel.
3. End.