PTP_1.3.6.1.4.1.2011.5.25.187.5.9 hwPtpAdaptiveClientListChange

Trap Buffer Description

The client list was refreshed. (hwPtpAdaptiveClientIpList=[hwPtpAdaptiveClientIpList], hwPtpAdaptiveClientIpChangeFlag=[hwPtpAdaptiveClientIpChangeFlag], hwPtpAdaptiveClientIndex=[hwPtpAdaptiveClientIndex], hwPtpAdaptiveClientId=[hwPtpAdaptiveClientId])

The status of the client list on the server is updated, and a client is added or deleted.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Event
Trap Severity	Warning
Mnemonic Code	PTPACRCLIENTLIST
Trap OID	1.3.6.1.4.1.2011.5.25.187.5.9
MIB	HUAWEI-PTP-MIB
Alarm ID	This is an event trap and does not involve alarm ID.
Alarm Name	This is an event trap and does not involve alarm name.
Alarm Type	This is an event trap and does not involve alarm type.
Raise or Clear	This is an event trap and does not involve alarm generation or clearance.
Match trap	-

Trap Buffer Parameters

Parameter	Description
hwPtpAdaptiveClientIpList	IP address of the client.
hwPtpAdaptiveClientIpChangeFlag	Refresh status of the client. The value can be: added(0), indicating that a new client successfully sets up a link. deleted(1), indicating that the original client is disconnected.
hwPtpAdaptiveClientIndex	Index of a client.
hwPtpAdaptiveClientId	Client ID.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.187.7.1.1.1	hwPtpAdaptiveClientIpList	hwPtpAdaptiveClientIpList
1.3.6.1.4.1.2011.5.25.187.1.55	hwPtpAdaptiveClientIpChangeFlag	-
1.3.6.1.4.1.2011.5.25.187.8.1.1.2	hwPtpAdaptiveClientId	hwPtpAdaptiveClientIndex

Impact on the System

The local clock may be inaccurate.

Possible Causes

Cause 1: A new client was configured and successfully negotiated with the server.

Cause 2: The client that has successfully negotiated with the server is disconnected from the server.

Procedure

1. Check the alarm information to obtain the IP address. Then, run the display ptp-adaptive all command on the device to view the list of clients that negotiate with the server and check whether the IP address exists.

If yes, the IP address is newly added, indicating that a new client has been configured. No further action is required. The procedure ends.
If not, it indicates that the client is disconnected from the server. In this case, go to Step 2.

2. Check the connection between the client and the server. You can run the ping command to check whether the link is normal.

If yes, go to Step 3.
If no, rectify the link fault.

3. Run the display current-configuration command to check whether the client configuration changes.

If yes, no action is required.
If no, go to Step 4.

4. Collect trap, log, and configuration information, and contact technical support.

5. End.