BRASAAA_1.3.6.1.4.1.2011.5.2.2.2.0.81 hwAAANoBackupInterfaceAlarm

Trap Buffer Description

The number of users on the interface with no backup protection configured has reached the alarm threshold.(Interface=[Interface], number=[number], threshold=[threshold], protection=[protection], level=[level])

The function to generate an alarm when the number of users on an interface with no backup protection configured reaches the threshold is supported.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Event
Trap Severity	Warning
Mnemonic Code	INTERFACE_NOBACK
Trap OID	1.3.6.1.4.1.2011.5.2.2.2.0.81
MIB	HUAWEI-AAA-MIB
Alarm ID	This is an event trap and does not involve alarm ID.
Alarm Name	This is an event trap and does not involve alarm name.
Alarm Type	This is an event trap and does not involve alarm type.
Raise or Clear	This is an event trap and does not involve alarm generation or clearance.
Match trap	-

Trap Buffer Parameters

Parameter	Description
Interface	specifies the name of an interface.
number	specifies the number of users on an interface with no backup protection configured.
threshold	specifies the alarm threshold for the number of users on an interface with no backup protection configured.
protection	specifies a backup protection type. hot indicates that neither access response delay based on odd and even MAC addresses or the remote-backup-profile command is configured on an interface that is not an inter-board Eth-Trunk interface. cold indicates that access response delay based on odd and even MAC addresses is configured on an interface but users with both odd and even MAC addresses go online from the interface.
level	specifies an alarm severity. The value can be minor and major.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.2.2.1.53	hwInterfaceName	-
1.3.6.1.4.1.2011.5.2.2.1.54	hwInterfaceUserNum	-
1.3.6.1.4.1.2011.5.2.2.1.55	hwInterfaceUserNumThreshold	-
1.3.6.1.4.1.2011.5.2.2.1.56	hwBackupProtectionType	-
1.3.6.1.4.1.2011.5.2.2.1.57	hwBackupProtectionAlarmLevel	-

Procedure

1. Run the remote-backup-profile profile-name command in the interface view to bind an RBP to the interface.

2. Run the access-delay delay-time command in the BAS interface view to configure a response delay policy for access users on the BAS interface.

3. Check whether the alarm is cleared.

If the alarm is cleared, go to Step 5.
If the alarm persists, go to Step 4.

4. Collect trap, log, and configuration information, and contact technical support personnel.

5. End.