DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.15 hwEntityCheckFail-68173

Trap Buffer Description

Physical entity is detected failed.(BaseTrapSeverity=16777216, BaseTrapProbableCause=68173, BaseTrapEventType=5, EntityPhysicalIndex=5, EntPhysicalContainedIn=3, EntPhysicalName=TSR_WHOLE frame <chassisID> , RelativeResource=NA, ReasonDescription=<chassisID> does not set fiber length.)

Physical entity is detected failed.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Critical
Mnemonic Code	hwEntityCheckFail
Trap OID	1.3.6.1.4.1.2011.5.25.129.2.1.15
MIB	HUAWEI-BASE-TRAP-MIB
Alarm ID	0x0813005d
Alarm Name	hwEntityCheckFail
Alarm Type	equipmentAlarm
Raise or Clear	Raise
Match trap	DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.16 hwEntityCheckResume-68173

Trap Buffer Parameters

Parameter	Description
BaseTrapSeverity	indicates the severity level of the trap reported to the NMS.
BaseTrapProbableCause	Indicates the possible cause of the trap.
BaseTrapEventType	Indicates the trap type.
EntityPhysicalIndex	Physical index. The physical index varies with the chassis ID.
EntPhysicalContainedIn	Indicates the parent index.
EntPhysicalName	Indicates the name of the entity such as a chassis.
RelativeResource	Indicates the name of the part related to the trap.
ReasonDescription	Indicates the description of the possible cause.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.129.1.1	hwBaseTrapSeverity	-
1.3.6.1.4.1.2011.5.25.129.1.2	hwBaseTrapProbableCause	-
1.3.6.1.4.1.2011.5.25.129.1.3	hwBaseTrapEventType	-
1.3.6.1.2.1.47.1.1.1.1.4	entPhysicalContainedIn	entPhysicalIndex
1.3.6.1.2.1.47.1.1.1.1.7	entPhysicalName	entPhysicalIndex
1.3.6.1.4.1.2011.5.25.129.1.4	hwBaseTrapRelativeResource	-
1.3.6.1.4.1.2011.5.25.129.1.5	hwBaseTrapReasonDescr	-

Impact on the System

The fabric system clock synchronized state is abnormal, and the traffic will be affected.

Possible Causes

The fiber length in 40G chassis is not set.

Procedure

1.Run the set fiber chassis chassis-id length fiber-length command to configure a correct optical fiber length, and check whether the trap is cleared.

If the trap is cleared, go to Step 3.
If the trap is not cleared, go to Step 2.

2. Collect the alarm information, log information, and configuration information, and contact technical support personnel.

3. End.