nqa bier ipv6 udp-port

Function

The nqa bier ipv6 udp-port command sets a UDP port number used to receive BIERv6 Echo Request messages.

The undo nqa bier ipv6 udp-port command restores the default configuration.

By default, the UDP port number is 49100.

Format

nqa bier ipv6 udp-port udpPort6

undo nqa bier ipv6 udp-port udpPort6

undo nqa bier ipv6 udp-port

Parameters

Parameter	Description	Value
udpPort6	Specifies the UDP port.	The value is an integer ranging from 1 to 65535.

Parameter

Description

Value

udpPort6

Specifies the UDP port.

The value is an integer ranging from 1 to 65535.

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
sla	write

Usage Guidelines

Usage Scenario

Before running the ping bier ipv6 or tracert bier ipv6 command, run the nqa bier ipv6 udp-port command to set the UDP port number for receiving request packets. Otherwise, the default UDP port number 49100 is used.

Precautions

The nqa bier ipv6 udp-port command only specifies the UDP port number but does not enable it. To enable a UDP port, run the undo nqa bier ipv6 echo-reply disable command and configure BIERv6 on the device.

If the UDP port number specified using the nqa bier ipv6 udp-port command has been used by another protocol, the UDP port number may fail to be occupied after the upgrade. As a result, the device cannot reply with a response packet. You can run the display udp ipv6 status command to check whether the UDP port is enabled.

Example

# Set a UDP port number to 4444, which is used to receive BIERv6 Echo Request messages.

<HUAWEI> system-view
[~HUAWEI] nqa bier ipv6 udp-port 4444