loss-measure single-ended-synthetic receive

Function

The loss-measure single-ended-synthetic receive command enables a peer device to receive synthetic loss measurement (SLM) frames for single-ended SLM.

The undo loss-measure single-ended-synthetic receive command disables the peer device from receiving SLM frames.

By default, no device in a Maintenance Association (MA) is enabled to receive SLM frames.

Format

loss-measure single-ended-synthetic receive test-id test-id [ time-out timeout-value ]

undo loss-measure single-ended-synthetic receive test-id test-id

Parameters

Parameter	Description	Value
test-id test-id	Specifies the ID of a test instance.	The value is an integer ranging from 1 to 4294967295.
time-out timeout-value	Timeout period for the receive end to receive SLM frames.	The value is an integer ranging from 10 to 300, in seconds. The default value is 300s.

Parameter

Description

Value

test-id test-id

Specifies the ID of a test instance.

The value is an integer ranging from 1 to 4294967295.

time-out timeout-value

Timeout period for the receive end to receive SLM frames.

The value is an integer ranging from 10 to 300, in seconds. The default value is 300s.

Views

MA view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
y1731	write

Usage Guidelines

Usage Scenario

After the loss-measure single-ended-synthetic send command is run to configure single-ended on-demand SLM and the loss-measure single-ended-synthetic continual send command is run to configure single-ended proactive SLM, run the loss-measure single-ended-synthetic receive command to enable the peer device to receive SLM frames.

Prerequisites

Ensure that the following commands have been run:

IEEE Standard 802.1ag-2007 of Connectivity Fault Management (CFM) has been specified using the cfm version standard command in the system view.
The CFM function has been enabled globally using the cfm enable (system view) command in the system view.
A Maintenance Domain (MD) has been created using the cfm md command in the system view.
A Maintenance Association (MA)has been created using the ma command in the MD view.
A test instance has been created using the test-id command.

Example

# Enable the peer device to receive SLM frames.

<HUAWEI> system-view
[~HUAWEI] mpls
[*HUAWEI-mpls] quit
[*HUAWEI] mpls l2vpn
[*HUAWEI-l2vpn] quit
[*HUAWEI] interface GigabitEthernet 0/1/1
[*HUAWEI-GigabitEthernet0/1/1] undo shutdown
[*HUAWEI-GigabitEthernet0/1/1] mpls l2vc 2.2.2.2 100
[*HUAWEI-GigabitEthernet0/1/1] quit
[*HUAWEI] cfm enable
[*HUAWEI] cfm md md1
[*HUAWEI-md-md1] ma ma1
[*HUAWEI-md-md1-ma-ma1] map mpls l2vc 2.2.2.2 100 raw
[*HUAWEI-md-md1-ma-ma1] mep mep-id 1 interface GigabitEthernet0/1/1 inward
[*HUAWEI-md-md1-ma-ma1] test-id 1 mep 1 mac 00e0-fc12-7890
[*HUAWEI-md-md1-ma-ma1] loss-measure single-ended-synthetic receive test-id 1 time-out 300