te link administrative group

Function

The te link administrative group command configures the link administrative group on an interface.

The undo te link administrative group command deletes the configuration.

By default, the value of the link administrative group is 0x0.

Format

te link administrative group group-value

undo te link administrative group

undo te link administrative group group-value

Parameters

Parameter	Description	Value
group-value	Sets a value for the link administrative group.	The value is a hexadecimal integer. The value range is 0x0 to 0xFFFFFFFF. Each of the 32 bits represents an attribute.

Parameter

Description

Value

group-value

Sets a value for the link administrative group.

The value is a hexadecimal integer. The value range is 0x0 to 0xFFFFFFFF. Each of the 32 bits represents an attribute.

Views

100ge sub-interface view, 100GE interface view, 10GE sub-interface view, 10GE interface view, 25GE sub-interface view, 25GE interface view, 400GE sub-interface view, 400GE interface view, 40GE sub-interface view, 40GE interface view, 50GE sub-interface view, 50GE interface view, Eth-Trunk sub-interface view, Eth-Trunk interface view, GE optical interface view, GE sub-interface view, GE electrical interface view, GMPLS-UNI interface view, Tunnel interface view, XGE sub-interface view, XGE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
mpls-te	write

Usage Guidelines

Usage Scenario

The link administrative group is a 32-bit vector representing a set of link attributes. It works with the affinity attribute for the system to determine the link that is used to set up a TE tunnel.

Configuration Impact

If the value of the link administrative group is changed using the command, the new value takes effect only for new LSPs, not for existing LSPs that have been set up before the new value is set.

Precautions

The command needs to be run only on the outbound interface of a link through which a TE tunnel passes.

MPLS TE-related commands apply only to MPLS TE and SR-MPLS TE. However, this command applies to SRv6 TE Policies, besides MPLS TE and SR-MPLS TE.

Example

# Set the value of the link administrative group to 0x0101.

<HUAWEI> system-view
[~HUAWEI] te attribute enable
[*HUAWEI] interface GigabitEthernet 0/1/0
[*HUAWEI-GigabitEthernet0/1/0] te link administrative group 101