access ipv6-address slot-warning-threshold

Function

The access ipv6-address slot-warning-threshold command configures upper and lower IPv6 address alarm thresholds for service boards.

The undo access ipv6-address slot-warning-threshold command restores the default configuration.

By default, the IPv6 address usage threshold-crossing alarm is not enabled on a board.

This command is supported only on the NetEngine 8000 F1A.

Format

access ipv6-address slot-warning-threshold upper-limit integer-value lower-limit integer-value

undo access ipv6-address slot-warning-threshold upper-limit integer-value lower-limit integer-value

Parameters

Parameter	Description	Value
lower-limit integer-value	Specifies a lower alarm threshold.	The value is an integer ranging from 0 to 99.
upper-limit integer-value	Specifies an upper alarm threshold.	The value is an integer ranging from 1 to 100.

Parameter

Description

Value

lower-limit integer-value

Specifies a lower alarm threshold.

The value is an integer ranging from 0 to 99.

upper-limit integer-value

Specifies an upper alarm threshold.

The value is an integer ranging from 1 to 100.

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bras-control	write

Usage Guidelines

Usage Scenario

To configure upper and lower IPv6 address alarm thresholds for service boards, run the access ipv6-address slot-warning-threshold command. When the percentage of the number of IPv6 addresses of access users on a service board in the IPv6 specification for the board exceeds the upper alarm threshold or goes below the lower alarm threshold, the device generates an alarm for the board.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

# Set the upper and lower IPv6 address alarm thresholds for service boards to 80% and 20%, respectively.

<HUAWEI> system-view
[~HUAWEI] access ipv6-address slot-warning-threshold upper-limit 80 lower-limit 20